S&S Cycle 510G Gear Drive Camshaft Kit. The 510G is designed as a bolt in cam for 88 to 95 inch engines with compression ratios below 9.7:1. Intended primarily for stock heads that have not been ported.
Can be used with stock springs. Kits reverse the rear cam's direction of rotation and provide additional operating clearance between cam lobes; the result is that higher cam lifts are possible with the gear drive kit.
Kits include cams, inner gears, inner and outer bearings, outer drive gears, gasket and instructions. Cams without any gears are also available - 14-8888. To install S&S gear drive cams, material must be removed from the inner surface of the stock gear cover. Cam bearings and gaskets must be replaced when installing new cams. Also, a hydraulic press and other professional-level tools are required to install these kits.
S&S recommends that adjustable pushrod/cover kit 14-9988 be used. For Cams only order 14-8888. Stock pushrods and valve springs acceptable.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance. Due to the inherent characteristics of gear drives, you may experience more valve train noise. (1) 5/16"-18 X 3/4" flange head bolt.Intake Lift at TDC (in). Exhaust Lift at TDC (in). 2006 Harley Davidson FLHX Street Glide. 2006 Harley Davidson FLHXI Street Glide. 2006 Harley Davidson FLST Heritage Softail. 2006 Harley Davidson FLSTI Heritage Softail. The item "S&S Cycle 510G Gear Drive Camshaft Cam Kit Harley Big Twin 99-06.510 # 33-5177" is in sale since Wednesday, March 25, 2015.
This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Engines & Engine Parts\Other Engines & Engine Parts". The seller is "americanclassicmotors" and is located in Zieglerville, Pennsylvania. This item can be shipped worldwide.